I picked up a small cordless phone battery from Radio Shack for $15 that was rated at 600mAh capacity. If you plan on replacing your battery, you'll need a soldering iron, a small bit of thin solder (you could likely get away without any if you're better than me), and a 3.6V Ni-Cd (original) or Ni-MH (preferred replacement) battery. I also used an electronics cleaner after cleaning up all the dirt. To perform a cleaning you will need a Phillips-head screwdriver, 50 cotton swabs, and a glass full of water. Unplug cabinet from wall, remove all cartridges. Below, I'll outline the steps and materials that I used to make my system nearly as good as (maybe even better) than the day it was made:Ġ. While you're at it, you might as well clean your boards too. The consequences? Often fatal to your board. After nearly two decades, many of these Ni-Cd batteries are beginning to leak. The most important thing you can do is replace the battery that is on it. Unless you have purchased from a fellow enthusiast, there is a good chance that your system has not received the attention that it needs. o r g / What to do when you buy a Neo-Geo MVS What to do when you buy a Neo-Geo MVS
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |